4116R LF PDF


R. R. R. PIN #1 REF. +/ +/ ). + / ( +/ . LF = Tin-plated (lead free). • Blank = Tin/Lead-plated. The RLF is a thick film Isolated Resistor Network with superior package integrity and compatible with automatic insertion equipment, DIP package of. Buy online R-LF 47 Ohm isolated resistor network by Bourns. Download Bourns R series network resistor t price and availability.

Author: Mezilkree Tot
Country: Belarus
Language: English (Spanish)
Genre: Software
Published (Last): 14 May 2015
Pages: 372
PDF File Size: 18.80 Mb
ePub File Size: 5.20 Mb
ISBN: 850-1-40354-940-9
Downloads: 49095
Price: Free* [*Free Regsitration Required]
Uploader: Akijas

A3 – 8 J5B. A4 – 16 etc Thanks for both of your replies. J1 – no luck: A3 – 4 J5B.

Arihav Electronics Inc. – Electronics Components

Hope this thread helps someone out one day! Ah my mistake, I was reading the pin numbers in place of the binary columns for lack of better words. Clamped the cable down and set the mux control lines up. Seems to be working OK, haven’t done much testing though.

Arduino-powered breakout board with a shift register for each meter? Multiply this by 10 and I’m wondering if it would cause responsiveness issues. A4 lg 5 etc instead of J5A.


Bourns 4116r LF 1-330 Resistor Network

Have swapped a couple of s in and out with no change. S0 I can even do it by hovering my finger close to said pin. I had a quick google around for MIDI throughput and only found something from which said it lt something 1416r 3. Letting the pot’s input float causes jitter as expected. The cables are short, maximum 10cm. Hi there, What would be the best way to handle several VU meters?

Removed all s but J5. Sign In Sign Up.


Community Reputation 0 Neutral. A1 – 2 J5A. Might be really obvious but it’s not clicking for me. Hope you guys can help: Still getting a large, constant stream of jitter. Well it works, somehow! Sidmonster was on the right track but I remade the wrong cable. Are these the correct resistor networks? Have been away for a while, exams and stuff.

All Activity Home Underskor. Unfortunately though I think I came home after a few drinks and poked around looking for shorts, so I don’t remember exactly where it was. To read the pot, I forced the lines on AIN.

  EPM7128SLC84 15 PDF

A0 – 1 J5A. I will admit I am intimidated by the idea of a BLM haha. Sometimes, during startup, all connected LEDs will turn on for a few seconds and then all off. Looks to be working! A0 – my pot! A2 – 4 J5A. Pin 5 of the is J1. Touching pins on AIN: A2 – 3 J5A. The reason I ask is because I’d like to disable all but the first mux J5A.

Anything I can try? I am still only at the very start of the controller design stage so I just want to make sure I don’t design anything that’s impractical.

Big 4116f to SmashTV and the guys on midibox, it was all them. J5 also causes activity. Here is an extract of the jitter so you can get an idea of the volume if that’s relevant:

Subscribe US Now