ASTM A/AM()e1. Standard Specification for Martensitic Stainless Steel Bars for High-Temperature Service. standard by ASTM. See the chemical composition and physical properties of ASTM A Grade S hot-rolled, find alternative materials, and connect with suppliers. See the chemical composition and physical properties of ASTM A Grade tempered, find alternative materials, and connect with suppliers.
|Published (Last):||18 April 2009|
|PDF File Size:||19.12 Mb|
|ePub File Size:||1.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
Stainless Steel Round Bar. The values stated in either inch-pound units or SI units are to be regarded separately as standard.
ASTM A for for Martensitic Stainless Steel Bars for High-Temperature Service
The material shall conform to the required mechanical properties such as tensile strength, yield strength, elongation, impact strength, and Brinell hardness.
The material shall also undergo stress rupture a655 using a combination test bar. Year of Establishment Rupture must occur in the smooth section of each test specimen. The material shall also undergo stress rupture testing using a combination test bar.
Grain size determination shall be performed in accordance with Test Methods E When the visual estimation method indicates the delta ferrite content is greater than the allowed limit, the manufacturer may employ Test Method E for determining w565 acceptability of the lot. Historical Version s – view previous versions of standard. Originally approved in Nature of Business Importer.
The mechanical properties shall be developed by suitable heat treatment, as indicated for each alloy. Stainless Steel Round Bars l.
ASTM A565 Grade 616 tempered
a65 Combining values from the two systems may result in nonconformance with the specification. When the average grain size is 5 or? Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.
Stainless Steel l Round Bar. This abstract is a brief summary of the referenced standard.
The following datasheet provides an overview of grade stainless steel. The mechanical properties are developed by suitable heat treatment, as indicated for each alloy. For sections greater than 30 in. The mechanical properties shall be developed by suitable heat treatment, as indicated for each alloy.
This standard has been approved for use by agencies of the Department of Defense. The method used shall be: For UT or ET, reject levels for linear indications shall be based on the alarm response from a 0. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
NOTE 2—Air or oil quenching depends on section size; heavier sections, approximately 3 in. Mechanical Properties Requirements 8.
The steel shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, molybdenum, vanadium, tungsten, nitrogen, aluminum, columbium, and copper.
Link to Active This link aa565 always route to the current Active version of the standard. Stainless steels are high-alloy steels that possess good corrosion resistance in comparison with other steels due to additional chromium content.
Combining values from the two systems may result in nonconformance with the speci? The values stated in either inch-pound units or SI units are to be regarded separately as standard. A number in parentheses indicates the year of last reapproval.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but asstm not provided as part of the standard. This specification covers hot-finished and cold-finished martensitic chromium steel bars for high-temperature service. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
The mechanical properties are developed by suitable heat treatment, as indicated for each alloy.