ASTM A – Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This standard is a part of ASTM. ASTM A March 10, Standard Specification for Annealed or Cold- Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This specification. ASTM A – Designation: A – 10 Standard Speci?cation for Annealed or Cold-Worked Austenitic.
|Published (Last):||3 October 2011|
|PDF File Size:||3.13 Mb|
|ePub File Size:||17.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values given in parentheses are for information only.
The noncontrolling factor normally will exceed considerably the speci? Hard Elongation in 2 in.
Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. Current edition approved Sept. However, in the case of dispute, tests shall be made by pressure. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Chemical equipment and piping, heat exchanger components, dairy and food handling equipment and utensils, cryogenic vessels and components, architectural and structural applications exposed to non-marine atmospheres.
A number in parentheses indicates the year of last reapproval. Find out what NKS can do for you. Types and L are weldable by most fusion or resistance welding techniques.
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
Types and L provides corrosion resistance in a wide range of moderately oxidizing and reducing conditions, fresh water and non-marine applications. Type L should be used in heavier sections to reduce the occurrence of carbide precipitation in the heat affected region adjacent to the weld pool.
D PSS means plate, strip, sheet. Maximum unless otherwise indicated.
A — 10 Standard Speci? Material Test Report and Certi? Only annealed conditions of grades speci?
Type L should be used in heavier sections to reduce the occurrence of carbide precipitation in the heat affected region adjacent to the weld pool Corrosion: HardC Elongation in 2 in. Last previous edition approved in as A — Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.
Originally approved in Heat to o F to o F and cool at sufficiently high rates through oF to oF to avoid precipitation of chromium carbides. Number a666-10 Tests 8. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their asttm responsibility.
ASTM A666 for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
Depending on the work hardening characteristics of the particular grade, either the yield or the tensile strength can be the controlling factor in meeting the properties. Rockwell A66-610 95 95 HRC typical L Ann 25 min. C Annealed material that naturally meets mechanical properties may be applied. In the annealed condition it is essentially non-magnetic and becomes slightly magnetic with the application of cold work.
and L Stainless Steel – NKS
One bend test shall be made from one end of each coil. In case of dispute, the offset method of determining yield strength shall be used. Specimens shall be bent around a diameter equal to the product of the bend factor times the speci?