KS datasheet, KS pdf, KS data sheet, datasheet, data sheet, pdf, Samsung 16COM / 40SEG DRIVER & CONTROLLER FOR DOT MATRIX LCD. Dot Matrix LCD Controller/Driver. V /6/ 1 KS and SED ○ Automatic reset circuit that The ST LCD driver consists of 16 common. Your LCD controller obviously has the correct power applied otherwise you would see smoke instead of blocks. Your backlight also appears to.

Author: Kigis Shagami
Country: Niger
Language: English (Spanish)
Genre: Love
Published (Last): 28 July 2014
Pages: 477
PDF File Size: 12.58 Mb
ePub File Size: 15.27 Mb
ISBN: 635-6-42354-843-7
Downloads: 19373
Price: Free* [*Free Regsitration Required]
Uploader: Mesida

HD44780 vs. KS0066

There are also no bridges between pins: It almost has to be something to do with kd0066 or more of the six data lines between the Arduino and the LCD. Added new getAddress method.

This site uses cookies to store information on your computer. Fixed memoryaddress confusion in address method. Access Warning You do not have the correct permissions to perform this operation. You do not have the correct permissions to coontroller this operation. The Hello World example. See the full wiki syntax in new window. That’s pin 5 as shown bere: By using the Potentiometer, Controllwr kan vary the intensitiy of the blocks from very dark to very light. By disabling cookies, some features of the site will not work.


Doesn’t matter which one, I would appreciated it if you posted both. The code you referenced is another example of this, and it’s worse than most. Important Information for this Arm website This site uses cookies to store information on your ks066. Your display of two rows of blocks is an indication that the LCD is not properly initialized. Refactored to fix issue with pins that are default declared as NC.

HD and compatible Text LCD controllers (4bit, I2C or SPI I/F) | Mbed

Essentials Only Full Version. I only changed the 16, 2 to 20, 4. The LiquidCrystal library isn’t totally correct either and that could possibly be your problem, but it’s not likely. This is the code I used. Why does my PIC32 run slower than expected?

Please post your sample code if you don’t controler, that would be most appreciated. Pin 16 wasn’t soldered that good, so I wired it again.

KS Datasheet pdf – 16COM / 40SEG DRIVER & CONTROLLER FOR DOT MATRIX LCD – Samsung Electronic

Accept and hide this message. Please log in to start a discussion or ask a question. I don’t know what happened to all the other Kcd guru’s. It’s got to be something simple that we are overlooking. I read of some Problems if the contrast isn’t adjusted properly. Note that there are several compatible LCD controllers around e.


I’m still thinking about it. I also tried this code to bar a mistake of the lcd library: I now found out, that the display hasn’t the HD Chip but an other which is almost the same.

LCD – controller : HD 44780 vs KS0066

What else can I try to fix this damn problem? User Control Panel Log out.

There are also controllers available that are compatible and provide additional features like an increased number of segment drivers for more characters or internal LCD contrast voltage generators e. Updated for more display types. This could be due to a wiring problem or a code problem.

Just changed the wireing in the code: Debug breakpoints automatically disabled 16F88 cannot set internal oscillator frequency beyond I found the data sheet here: I checked the other pins by using the “diode” test of my multimeter one Pin to the soldered Pin, the other to the board.

We are back to this “The reversed backlight connections that seem to work OK still bother me as well.

Subscribe US Now